Reasons why it is advantageous to replace the T8 (T10, T12) lamps into the T5 systems:

1. In comparison with electromagnetic systems T8 (T10, T12), the T5 system will save 40-50% electric energy, reducing the cost of lighting. 
2. There is no need to change the existing lightings; the T5 system will be installed in place of of the old lamps.

3. Easy to install, it is the same as changing the burnt bulb. It does not require a lot of working expenses executing provisions of the EU Directive 2005/32/EC.
4. The power factor increases from 0.5 (using electromagnetic ballasts) to 0.98. Electrical flow decreases 3-5 times, allowing the system to reduce power loss and thus save energy.
5. The T5 system starts immediately without flickering, even at low temperature or low voltage.
6. Better color efficiency.
7. High-frequency electronic ballast protects your eyes from the 50Hz light flickering caused by electromagnetic ballasts.
8. There is no noise that is characteristic of the T8/T10/T12 electromagnetic systems.
9. Less heat generation of T5 system indirectly saves energy in reducing the load of air-conditioning system.
10. T5 system’s reflector directs light in any direction and thus improves efficiency of the system, saves more power.

Three simple installation steps:

I.       Remove the old T8 lamp; II.      Remove starter from the existing luminaire; III.     Plug in the T5 system into the original T8 fixture.That’s all, now you can switch it on!